Support interference signal and deception signal detection, and output alarm information

Can receive multiple time references and has the ability to measure and monitor time references

Equipped with LCD time display (year/month/day/day/hour/minute/second) and parameter configuration function

Built in high-performance frequency source (rubidium clock or crystal oscillator) with automatic frequency calibration function

Multiple time codes, pulses, frequencies, and other signals can be selected for output

Adapt to user needs and provide various forms of products 1U/2U/3U

Equipped with fault alarm prompt function and capable of monitoring device status through serial port/network

Supports multicast and unicast modes

Working mode: Master or Slave mode, One step or Two step mode

Support P2P and E2E latency mechanisms

Can choose rubidium clock or constant temperature crystal oscillator

NTP response times:>140000 times/second

Built in high-performance rubidium clock and low phase noise constant temperature crystal oscillator

Support external time-frequency signal measurement and reporting function

Support high-precision time and frequency signal output

Built in WEB management platform, convenient for viewing device status and setting parameters

Optional configuration with built-in battery, convenient for moving and working with power on

Optional high-precision time synchronization between multiple devices, with synchronization accuracy better than 2ns

Output sine wave

Short term stability can reach<6E-13/S

Accuracy: 25ns relative to Coordinated Universal Time

Phase noise<-110dBc/ Hz@1Hz (Optional)

Supports 100MHz output (optional)

Output sine wave

Short term stability can reach<3E-13/s

phase noise <-115dBc/ Hz@1Hz

Optional 10/100MHz output

Integrated device for positioning, orientation, and timing

Built in full frequency, full system satellite receiver

Can support BeiDou(COMPASS) 3rd generation and military code requirements

Flexible configuration of output channels

Support forwarding and generative deception, interference signal detection, and alarm output

Support prevention of forwarded, generated, and invasive signal spoofing

Optional Rubidium clock or constant temperature Crystal shaker as navigation frequency source

Output normal satellite signal function under deception and interference conditions

Adjustable output signal strength (power)

Support remote WEB monitoring of device working status and setting of working parameters

Tested by the Experimental Verification Center of State Grid Electric Power Research Institute

Supports full height or half height sizes

PTP supports electrical or optical port modes

Capable of high-precision punctuality

Interrupt frequency 1-1000Hz configurable

Support SNMP protocol and WEB monitoring

The driver supports commonly used operating systems such as Windows, Linux, QNX, and rtLinux

100% national production design

Small size, low power consumption

Can receive signals from satellites, B-code, 1PPS+TOD, etc. to tame Crystal shaker

Can output signals such as B (DC), 1PPS, TOD time code, NTP, PTP, etc

Can be configured to output 10MHz or other specific frequency signals

Capable of high-precision punctuality